Measure the closest point to the side of the bed and record down the figure.

You should place the end of the measuring tape at the bulkhead or space where the truck bed attaches to the back of the cab.

The trick in measuring the truck bed is to measure the length in inches at least twice to get it correctly. However, there are three specific nomenclatures that are pursued in truck bed measurements short, standard and long bed. Also, you should be aware that not all automotive manufacturers make beds of the same length. To begin, have a measuring device that extends beyond 10 feet and a paper to write or your phone’s notes app to record the measurements. You should know that not every truck’s measurements are the same as indicated in the vehicle manual. It’s crucial to understand the dimensions of your truck’s bed length before ordering a tonneau cover. Problems measuring a tonneau cover for your truck? Consider checking out our post about opening different tonneau covers. Apply some lubrication to these areas and check to see if there is some damage or general depreciation due to age and frequent use. When your tonneau cover won’t open or becomes stuck, there could be some rust in the opening mechanism. However, it might start to get stuck or become harder to operate over time. If a tonneau cover seal is damaged or has fallen off, the cover can flip hence allowing air, dust, and water to penetrate and damage the hard retractable cover further and faster The cover won’t open or becomes stuckĪ good tonneau cover should smoothly glide while opening and closing it. If a seal is damaged or missing, you must replace or repair the tonneau cover as soon as possible to prevent further damage or the cover wearing out faster than it should. A defect could be making the cover to pull away in certain truck bed regions. You should also ascertain that nothing came loose or even damaged when purchasing.

Tonneau cover noises are mostly caused by a loose installation or damages to the cover that allow air to enter inside the truck bed through holes or cracks. However, if your cover isn’t fitted well, then you will hear some noises. Noisy tonneau coversA correctly fitted and installed cover lies snugly across the truck and shouldn’t make any noise. In case, you have a plastic drop-in bed liner, where all of them cover the front rail of the bed, you will need to check the outer edge of front bed rail to make sure that the bed-liner portion does cover the whole width of the front bed rail without leaving a void for water to sneak in. If these parts are on the same level, you can add extra foam to the front section of the truck bed. A slanting effect helps water to drain from the covers. You should always inspect the front bulkhead or the front of the truck bed to ensure it is not at the same level as sides of the bed before installing the cover. The tail seal is very efficient in preventing moisture and shutting the dust out. To prevent your tonneau cover from leaking, you should use a tailgate cover seal that covers both the gap along the bottom and both sides of the tailgate. Another cause of tonneau leakages is pressurized water that penetrates between the edges of the covers while the vehicle is being washed.

In this case, we have a guide for fixing a leaking tonneau cover. The rain that hits the covers from above or on vertical angles rarely causes leakage, unless your tonneau cover is damaged. Tonneau covers are designed to be watertight.

Paint fx snow cover